Service Guide
Connecting the service terminal
This section contains the hardware information needed to interconnect the service terminal.
Attention:
You will need HyperTerminal to read the messages.
Note:
Service terminal settings must be:
19200 baud
8 data bits
No parity
1 stop bit
Hardware Required
RS-232 DB9F to DB9F null modem cable
Desktop computer or laptop computer, or a 232 DTE terminal, or a desktop or laptop computer that runs terminal emulation software
RS-232 DB9M to DB25F adapter if the terminal uses a DB25M connector
[
Top of Page
|
Previous Page
|
Next Page
|
Table of Contents
|
Index
]