Table 14 describes POST error codes and their suggested actions. X can be any number or letter.
Error Code/Symptom | Meaning | Suspected Part/Suggested Action | ||
---|---|---|---|---|
062 | Three consecutive boot failures using the default configuration | Suspected part:
Suggested action: Run Configuration/Setup | ||
101, 102 | System and processor error | Suspected part:
| ||
106 | System and processor error | Suspected part:
| ||
111 | Channel check error | Suspected part:
| ||
114 | Adapter read-only memory error | Suspected part:
| ||
129 | Internal cache error | Suspected part:
| ||
151 | Real time clock error | Suspected part:
Suggested action: Run Diagnostics | ||
161 | Real time clock battery error | Suspected part:
Suggested action: Run Configuration/Setup | ||
162 | Device Configuration error | Suspected part:
Suggested action: Run Configuration/Setup
| ||
163 | Real-Time Clock error | Suspected part:
Suggested action: Run Configuration/Setup | ||
164 | Memory configuration changed | Suspected part:
Suggested action: Run Configuration/Setup | ||
175 | Hardware error | Suspected part:
| ||
176 | Computer cover or cable cover was removed without a key being used | Suspected part:
Suggested action: Run Configuration/Setup | ||
177, 178 | Security hardware error | Suspected part: System Board
Suggested action: Run Configuration/Setup | ||
184 | Power-on password corrupted | Suspected part: System Board
Suggested action: Run Configuration/Setup | ||
185 | Drive startup sequence information corrupted | Suspected part: System Board
Suggested action: Run Configuration/Setup | ||
186 | Security hardware control logic failed | Suspected part: System Board
Suggested action: Run Configuration/Setup | ||
187 | VPD serial number not set | Suspected part: System Board
Suggested action: Set serial number in Setup | ||
188 | Bad EEPROM CRC #2 | Suspected part: System Board
Suggested action: Run Configuration/Setup | ||
189 | An attempt was made to access the appliance with invalid passwords | Suggested action: Run Configuration/Setup, enter the administrator password | ||
201 | Memory test error | Suspected part:
Suggested action: If the appliance does not have the latest level of BIOS installed, update the BIOS to the latest level and run the diagnostic program again. | ||
229 | Cache error | Suspected part:
Suggested action: Run Configuration/Setup | ||
262 | DRAM parity configuration error | Suspected part:
| ||
289 | DIMM has been disabled by the user or system | Suspected part: Processor/PCI Board
Suggested action:
| ||
301 | Keyboard or keyboard controller error | Suspected part:
| ||
303 | Keyboard controller error | Suspected part:
| ||
602 | Invalid diskette boot record | Suspected part:
| ||
604 | Diskette drive error | Suspected part:
Suggested action: Run Configuration/Setup and Diagnostics | ||
605 | Unlock failure | Suspected part:
| ||
662 | Diskette drive configuration error | Suspected part:
Suggested action: Run Configuration/Setup and Diagnostics | ||
762 | Coprocessor configuration error | Suspected part:
Suggested action: Run Configuration/Setup | ||
962 | Parallel port error | Suspected part: System Board
Suggested action:
| ||
11XX | System board serial port 1 or 2 error | Suggested action:
| ||
0001200 | Machine check architecture error | Suspected part:
| ||
0001295 | ECC circuit check | Suspected part:
Processor/PCI Board | ||
1301 | I2C cable to front panel not found | Suspected part:
| ||
1302 | I2C cable from system board to power on and reset switches not found | Suspected part:
| ||
1303 | I2C cable from system board to power backplane not found | Suspected part:
| ||
1304 | I2C cable to diagnostic LED board not found | Suspected part:
| ||
1600 | The Service Processor is not functioning | Suspected part:
Suggested action: Do the following before replacing:
| ||
1601 | The system is able to communicate to the Service Processor, but the Service Processor failed to respond at the start of POST | Suspected part:
Suggested action: Do the following before replacing a part:
| ||
1762 | Hard Disk Configuration error | Suspected part:
Suggested action:
| ||
178X | Hard Disk error | Suspected part:
Suggested action:
| ||
1800 | No more hardware interrupt available for PCI adapter | Suspected part:
Suggested action:
| ||
1962 | Drive does not contain a valid boot sector | Suspected part:
Suggested action:
| ||
2400 | Video controller test failure | Suspected part:
| ||
2462 | Video memory configuration error | Suspected part:
| ||
5962 | IDE CD-ROM configuration error | Suspected part:
Suggested action:
| ||
8603 | Pointing Device error | Suspected part:
| ||
00019501 | Processor 1 is not functioning | Suspected part:
Suggested action: Check VRM and processor LEDs | ||
00019502 | Processor 2 is not functioning | Suspected part:
Suggested action: Check VRM and processor LEDs | ||
00019701 | Processor 1 failed BIST | Suspected part:
| ||
00019702 | Processor 2 failed BIST | Suspected part:
| ||
00180100 | No room for PCI option ROM | Suspected part:
Suggested action:
| ||
00180200 | No more I/O space available for PCI adapter | Suspected part:
Suggested action:
| ||
00180300 | No more memory (above 1 MB for PCI adapter) | Suspected part:
Suggested action:
| ||
00180400 | No more memory (below 1 MB for PCI adapter) | Suspected part:
Suggested action:
| ||
00180500 | PCI option ROM checksum error | Suspected part:
System Board Suggested action:
| ||
00180600 | PCI built-in self-test failure; PCI to PCI Bridge error | Suspected part:
Suggested action:
| ||
00180700, 00180800 | General PCI error | Suspected part:
| ||
01295085 | ECC checking hardware test error | Suspected part:
| ||
01298001 | No update data for processor 1 | Suspected part: Processor 1
Suggested action: Ensure all processors are the same stepping level and cache size. | ||
01298002 | No update data for processor 2 | Suspected part: Processor 2
Suggested action: Ensure all processors are the same stepping level and cache size. | ||
01298101 | Bad update data for processor 1 | Suspected part: Processor 1
Suggested action: Ensure all processors are the same stepping level and cache size. | ||
01298102 | Bad update data for processor 2 | Suspected part: Processor 2
Suggested action: Ensure all processors are the same stepping level and cache size. | ||
I9990301 | Fixed boot sector error | Suspected part:
| ||
I9990305 | Fixed boot sector error, no operating system installed | Suggested action: Install the operating system to the hard disk drive | ||
I9990650 | AC power has been restored | Suspected part: Power Cable
Suggested action:
|