Corrections to the Exabyte Eliant 820 SCSI Reference (316869-002) Chapter 9, page 9-13: In "Minutes Since Last Clean": "Indicates the number of power-on minutes since the tape drive was last cleaned." should be changed to: "Indicates the number of tape motion minutes since the tape drive was last cleaned." Chapter 10, page 10-16: In Table 10-8, Density Code 14h, the sentence: "If you attempt to write after specifying this Density Code with MODE SELECT, the tape drive returns Check Condition status with the sense key set to Illegal Request (5h) and an FSC of D0h." should be changed to: "If you attempt to write after specifying this Density Code with MODE SELECT, the tape drive returns Check Condition status with the sense key set to Illegal Request (5h) and an FSC of DBh." Chapter 19, page 19-1: In the third paragraph, the sentence: "If the tape drive is reserved and any command (other than an INQUIRY (12h), PREVENT/ALLOW MEDIUM REMOVAL (1Eh), or REQUEST SENSE (03h) command) is received from another initiator, the command will not be honored." should be changed to "If the tape drive is reserved and any command (other than an INQUIRY (12h), PREVENT/ALLOW MEDIUM REMOVAL (1Eh) with the prevent bit set to 0, or REQUEST SENSE (03h) command) is received from another initiator, the command will not be honored." Chapter 21, pages 21-2 and 21-4: The Parameter List Length field supports only a value of 0000. If a non-zero value is loaded into the field, the command is rejected with Check Condition status. The sense key is set to 5h (Illegal Request). The ASC is 24h and the ASCQ is 00h. The FCS is CEh (Invalid field or reserved bits set in the CDB.) In Table 21-1 on page 21-4, the only valid Parameter List Length is 0. Home | News & Info | Products | Customer Care | Support Services | Government | Search | Partner Central | Contact | Site Index © Copyright 2000 Exabyte Corporation, 1685 38th Street, Boulder, Colorado 80301, U.S.A., All rights reserved.